MAMOD BOILER END CAP
1.75 " Dia x 5/16th "
For your Mamod engine renovation project.
You can use this in two possible ways.
1. If you have a boiler with a cap on one end that you wish to replace, simply heat up that flange and when the solder is melting, gently tap it off in such a way that you do not damage/dent the boiler. You can use a piece of batten tapped kindly with a small hammer.
2. If a boiler seems ruined because of problems at the the water level plug/ sight glass end, it is quite possible to hacksaw off that end. You can then fit a Water Level Plug (make sure you drill the hole in the correct place and NOT in the middle).
And then you can fit on the Blanking Cap and finish off with soft solder.
I have done this and it works!