Flywheels / Pulleys / Crank
ROADSTER ETC. SA1
This pulley fits onto the back axle and is joined by drive band (driving) to the brass pulley close to the flywheel (get it?).
The diameter is 58mm.
This is the pulley that fits the current style SA1, WHERE BOTH DRIVE BANDS ARE ON THE SAME SIDE OF THE VEHICLE.
There is a short drive band that connects this Pulley to the Flywheel and a longer one that connects the Flywhel to the driving road wheel.
This 32mm diameter pulley has no screw fixing but is an interference fit onto the shaft. If it is not a tight fit you can use a drop of Loctite or super glue.
Dimension: Shaft Length 101mm.
The shaft diameter is suitable for all current engines and almost all older engines but not the small MM1 stationary engine. No one makes those now.
You will have to measure and cut to length using a hack saw for all engines other than the SA1 Roadster.
ROADSTER ETC. SA1
This is made for the SA1 type vehicles such as the Steam Roadster.
DIMENSIONS: OD 1.89 INS/ ID 0.185 INS
ROADSTER ETC. SA1
This is made for the SA1 type vehicles such as the Steam Roadster.
BLACK INTRODUCED 2020.
DIMENSIONS: OD 1.89 INS/ ID 0.185 INS
MECCANO / SP3 ENGINE / WS1 workshop line shaft pulley.
This is the best we can do to provide you with a new flywheel .........
Read on....................
TRACTION ENGINE TE1/TE1A -STEAM ROLLER SR1A
This is the Standard Flywheel sold by Mamod today for all of their engines (except SW1/SP4/SP5/SE3).
DIMENSIONS: OD 53.50mm/ ID 4.70mm
SP4 / SP5 and the old SE3 engine.
Now supplied by Mamod fully painted around the rim.
A brass screw attaches this to the crankshaft.
The dimensions are: Dia. 63.80mm, Crank shaft hole 4.73mm and width 12.34mm.
This "Balance Wheel" sits just below the red Flywheel.
It has its own axle and two Hub Caps~ which are included in the price.
Note:
All other parts displayed in this detail photo are not included on the offering.
This is the standard Mamod produced Steam Wagon Flywheel in red.
I