RIVETS
Rivets for Mamod engine repairs.
FOR YOUR BOILER.......50 rivets
These blind copper rivets can be used on a boiler because they are completely sealed front to back when the pin has been drawn through.
This set of rivets is for a partial renovation / repair.................................
This set of rivets is for the engine without or without Sight Glass Assembly.
3/32" x 4 for Smoke Box
3/32" x 4 for Fire Box
3/32" x 4 for Canopy top (early type)
1/8" x 4 for Canopy support top and bottom bracket
1/8" x 2 for Crank Support Bracket
3.2 Copper x 2 for Firebox / Boiler
3.2 Copper x 2 Sight Glass Assembly with rivets (may not be required)
Also suitable for renovating the SA1 vehicles.
Total 22 rivets.
If you need any help or guidance please call Trevor at Model Enthusiasts on 0777 552 1452.
GET FIXING!
1/8 inch diameter. Fifty rivets per pack.
These rivets are used for fitting an engine face mounting bracket in place.
GET FIXING!
1/8 inch diameter. Ten rivets per pack. These rivets are used for fitting an engine cowling in place. Whether it is an SA1 vehicle.............................
GET FIXING!
3/32 inch diameter. Fifty rivets per pack. These rivets are used for fitting an engine cowling in place. Whether it is an SA1 vehicle (car etc.) or a TE1A type (traction engine etc.) there are four rivets required to secure the cowling. However, it is always sensible to buy more than you think you need! If you need any advice, please contact us.
GET FIXING!
3/32 inch diameter. Ten rivets per pack. These rivets are used for fitting an engine cowling in place. Whether it is...........
FOR YOUR BOILER....... FIFTY SEALED END COPPER RIVETS 3.2MM X 6.50MM
FOR YOUR BOILER....... TEN SEALED END COPPER RIVETS 3.2MM X 6.50MM
FOR YOUR BOILER.......
These blind copper rivets can be used on a boiler .......................................